International Interplus 4103 Clean Cons

SKU
ID23963
Non Hazardous
A single component, water-based rust remover / cleaner gel for a range of substrates.
Available in 25 Litres
From £1,182.16 £985.13
In stock
Only %1 left
Product Description

International Interplus 4103 Clean Cons is 100% biological degradable and free from toxins. It conforms to the yellow classification of the Harmonised Offshore Chemical Notification Format (HOCNF).

Best Uses

Interplus 4103 is for the removal of light to medium rust on a variety of surfaces, including carbon steel, stainless steel, plastic and polyester. It is suitable for use in the following:

  • Cleaning Pipe Systems
  • Coolers
  • Heat Exchangers
  • or for use in drip trays

Application

Remove any loose rust deposits prior to application of Interplus 4103 Clean Cons. This will aid in the penetration of the product. Ensure that any surfaces that are NOT being treated, are masked and protected with polyethylene. A strong ground sheet should be used to contain residue, product and rinse water.

Galvanised surfaces can be affected by Interplus 4103 Clean Cons; therefore these areas should be covered. Be aware that use of Interplus 4103 Clean Cons on GRP will cause discolouration of the surface.

Oil or grease should be removed in accordance with SSPC-SP1 solvent cleaning.

Application Conditions

Optimal working temperature range is 8 - 50°C (46 - 122°F). Interplus 4103 Clean Cons can be used at temperatures as low as 2°C (36°F) and a maximum of 60°C (140°F), but a lower level of performance should be expected.

For best results, it is advised to suitably cover the application area to reduce the effect of wind, rain and intense sunlight.

When applying Interplus 4103 Clean Cons in confined spaces, ensure adequate ventilation.

System Compatibility

The following primers are approved for application direct to steel surfaces treated with Interplus 4103 Clean Cons:

 

Technical Details

Certificates and Approvals

  • Interplus 4103 Clean Cons conforms to the yellow classification of the Harmonised Offshore Chemical Notification Format (HOCNF).

System Compatibility

To ensure good overcoating of approved maintenance primers, it is important that the treated surface is free from all residue contamination and a thorough rinsing and wash down has been undertaken.

The surface should be clean and dry prior to overcoating with approved primers.

Technical Info

Components: Single Pack
Type: Rust Remover
Finish: n/a
Stock Colours: Yellow
Tintable: No
VOC Content: 0 g/lt
Volume Solids: -
Suitable Substrates: Carbon steel, stainless steel, plastic and polyester.
Application Method: Brush, Roller
Time to take effect: 4 - 24 hours, depending on the type of surface and the temperature.
Mixing: Dilute with clean potable water only
Fully Cured: -
Cleaner / Thinner: Clean potable water
Shelf Life: 2 years from date of production unopened 
Packaging: Available in 25 Litres

Related Products